RSVP
RSVP requires both Location RSVP setup (LBM) and IOS global, interface and MTP configuration for RSVP and for QoS. RSVP is used for Voice and Video by CUCM and CME. Continue Reading →
ACI Data Center & DevOps
RSVP requires both Location RSVP setup (LBM) and IOS global, interface and MTP configuration for RSVP and for QoS. RSVP is used for Voice and Video by CUCM and CME. Continue Reading →
Configuring Meetme on CME On phone, press MeetMe button then dial 5002222 to create conference, conference creator should have “conference admin” configured. Other phones may then join dialling 5002222 only. Continue Reading →
A DSPFarm on a router is a pool of DSP resources configured for particular functions (services); XCODE MTP Conference Bridge This DSPFarm needs to register itself (the DSPFarm and resource Continue Reading →
POTS DialPeer – Block Inbound Calls Based On CLID (Whitelist Example) This is applies to a POTS port for incoming calls from the connected PSTN (ISDN) Peer. So the router Continue Reading →
Wildcards and Special Characters in Route Patterns and Hunt Pilots in CUCM and voice translation patterns in IOS. CUCM Wildcards and special characters in route patterns and hunt pilots allow Continue Reading →
It displays your cookie file which should look something like this: 04 ff c3 06 00 1e 4a 8c 7d d1 43 00 22 c1 8b 46 4f 43 31 Continue Reading →
RSVP requires both Location RSVP setup (LBM) and IOS global, interface and MTP configuration for RSVP and for QoS. RSVP is used for Voice and Video by CUCM and CME. Continue Reading →
In order to have CUCM use a SIP trunk and SIP OPTIONS to monitor the router the minimum required is a dial-peer setup, without this the SIP OPTIONS PING from Continue Reading →
FXO Ports On IOS (BT Connected) ! voice-port 0/0/1 no battery-reversal cptone GB timing sup-disconnect 85 connection plar opx 1390 impedance complex3 caller-id enable caller-id alerting line-reversal caller-id alerting dsp-pre-allocate Continue Reading →
IOS Configuration (SIP) Note: global “mode” not set; by default is SRST, only option is CME to set, so unset is SRST. Minimum Configuration ! voice register global system message Continue Reading →